Those spring perches are weak ass for sure!

do this ,,        minus the  chain bridge

somethin like this i suck at darwing on here though  

Stuff a huge spring in and lay low.  requires a coil over setup. a power ball or clevis. 6'' scedule 40 sps gas pipe cut to whatever length you want under there. Cut out a arm and box it in.  remove all the alignment shims . cut the a arm truss  leaving the alignment  bolt mount . cut out a 6 1/4 inch hole in frame and upper spring perch mount. tack in pipe to frame of the truck. bend a 3/4 '' piece of round stock around pipe and cut to size to fit ,around the pipe to the a arm truss and 45 degree the ends and weld to the truss. reinstall shims so now it dosent tough the pipe but it can travel for future alignments.  on the top of the tower you have to cut out a 6'' x 3/8 thick round  plate to weld over the top leaving a 3'' hole.  cut out  a 4'' x 3/8'' round plate and cut a 2''  hole in the center . drill and tap 3 holes through both plates 3/8 16 thread. Then you cut a piece of scedule 40 pipe with a 1 9/16 inside or equivelent to your cylinder size for a not tight fit. weld it in the center of the 4'' plate for the cylinder to slide into. then you run your plumbing directly up off the top of the cylinder out of the tower leaving enough for it to travel up. Then you have to chain off the lower control arm as your suspention stop.

ANY QUESTIONS? :blink:  

sold  

Under construction  

i have 2 reds pumps and 4 dumps i jus bought a 90 b2200 and it came with them kinda instaled and they dont work but tha guy asured me that they do and i would like to re wire them but i dont know how. there r 6 selinoids 4 deep cycle batts 8 switches. i want to start from scratch on wireing so any help would be great...


Thanx N|ck

if your in ct bring it by my shop for a profesional install ,  

You can run 1 pump with a manifold or 8 dumps. you can run 2 pumps  , 4 dumps each, you can run 4 pumps 4 dumps,  or 3 pumps  one dump on each of 2,, 4 dumps on 1,  any of these setups allow individual corners,    just do basic 2 pumps 4 dumps for now ,    

That would make a single pump  be able to control individual corners , like a 2 pump to the rear for a chain bridge,,  It works like this ...    You have to wire the switch box differant..  when you want to lift the rear cylinders, you have to have a 24 volt signal to the dumps that are hooked up normally closed so they open so the pump will lift, now when you want to lift one cylinder you only need to open one of the normally closed dumps , There the same dumps  just look at the way there plumbed, the pressure is running to the normally closed side..   Thats not my diagrams, just a concept that functions.. It works.  

B)

       

 

84 scirocco ,  1.8 ,     5 speed , sunroof, pm , pw,  needs cosmetic work . trade for cash or hydraulic parts :blink:  

The output on the pumphead to block seal could be shot.