|
Title: Added terminal for battery postive and grounds Post by: Hydros on January 27, 2013, 12:09:56 AM Here we have the ground for the body/frame going directly to the negative side of the ground connector, and extra posts for direct grounds for the dumps, pumps and solenoids. Everything is tied onto one ground.
And the positive is using studs from solenoids, soldered on for some but not all 24VDC connections. The single 24VDC battery positive cable is going to one of the solenoids and then connects all solenoids to 24VDC, so as to have a cleaner look. I was going to use a copper strip to make a mount for all the postive terminals. This would have been between the solenoid for the front and for the rear. But decided to make it a litter easier to connect other positives for testing. I was going to solder on female wiring termial for fast connect and disconnect, but, it was too much trouble. Just add a loop terminal for the hardware to connect to positive. When you wire up your ground disconnect, be sure to have the female end connecting to the battery. |