|
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:45:02 PM I had a few extra electrical solenoids and decided to replace one on a valve I had.
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:47:58 PM Looking at a few different part numbers.
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:49:18 PM Notice one has a metal washer.
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:51:46 PM Just remove the top nut and slide the old sol off.
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:53:16 PM Here is how it looks apart piece by piece. Not all valves will look the same, this just gives an idea.
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:57:49 PM New sol. getting ready to tighten down. There is no need to tighten this but too tight. I'd say snug will do.
Title: Replacing electrical solenoid Post by: Hydros on May 08, 2005, 01:59:06 PM Here it is ready to apply voltage and see if it clicks. This is a 12vdc unit.
Just clicking doesn't mean that it will hold pressure. |